6
© 2004 PANORAMAdtv ALL rights reserved
MON8-1
User Manual P/N
821568
Rev-
A
1
Please refer to
Figure-2a
on the following page to familiarize yourself with the front panel features of the
MON8-1
unit. The following
sections describe these functions and are referenced, by
number
, to
Figure-2a
.
Section 2: Operation
Front Panel Features
Video Displays (1-8)
View input video sources through these eight 1.75" diagonal LED backlit LCD displays. Screen image parameters are factory preset
for optimum performance. The numbers shown at the lower right of each display (
1
-
8
) correspond to the numbers of the associated
input sections on the rear panel (
Item C
).
A
B
C
Please refer to
Figure-2a
on the following page to familiarize yourself with the rear panel features of a
MON8-1
unit. The following
sections describe these features and are referenced, by
letter
, to
Figure-2a
.
Rear Panel Features
Power Connector
Attach a standard IEC-320 power cord between this connector and mains power.
Termination DIP Module (CVBS Video Inputs)
Each switch in this two-section DIP module is used to set the termination characteristics for the input connector next to it. If
the
LOOP CVBS
connector is connected to downstream equipment, set to
LIFT
(UP) to
unterminate
the input. If
no
downstream equipment is connected, then set to
TERM
(DOWN) to
terminate
the input.
CVBS Video Input Sections (1-8)
Each unit is configured with eight
CVBS
inputs and eight loop-through outputs. Each input section is numbered (
1
-
8
) to
correspond to the associated display on the front panel.
IN CVBS Connector:
Connect standard composite analog (
CVBS
) video signals here. NTSC or PAL standards are accommodated
automatically. Termination is 75 Ohms when applied (see
Item B
).
LOOP CVBS Connector:
This connector is a loop-through output of the signals entering vthe
CVBS IN
connector. If this output is connected
to downstream equipment, then the
Termination
should be removed for the input (
Item B
).
