© 2006 PANORAMAdtv ALL rights reserved
19
MON3-3
User Manual P/N
821514
Rev-
E
CVBS (MAV-1) Input Option Field Upgrade
Field Upgrading
This section explains the procedures for field upgrading your unit with additional composite video (CVBS) input
module(s).
We advise you remove the MON3-3 from the mounting frame and work with the unit on a clean, well lighted
work bench.
Ensure the MON3-3 is disconnected from the power mains.
Remove top cover. Retain screws for later reassembly.
Remove blanking plugs from slot where MAV-1 is to be installed. (Rear panel sections 2A and/or 3A)
Remove flat ribbon cable from rear I/O PC board. (Horizontal removal/insertion.).
Cut termination resistor from rear main board at the point labeled “B Input Cutout”. (Note: this is to allow
HI-Z/75 ohm termination selection from the MAV-1 board).
Install the flat ribbon connector supplied with the interface into the connector the ribbon was disconnected
from in step #4.
Insert the flat ribbon into the rear (horizontal) flat ribbon connector labeled “J3” on the MAV-1 board.
Insert the flat ribbon cable to the front LCD into the inboard (vertical) flat ribbon connector labeled “J4” on
the MAV-1 board.
Attach the MAV-1 to the rear panel using the supplied BNC nuts.
Double check all wiring and connections.
Connect CVBS signal and confirm operation.
Replace cover and return unit to service.
1)
2)
3)
4)
5)
6)
7)
8)
9)
10)
11)
12)
13)
Note:
Each channel can accept only one additional input option; either an SDI (MSDI-4) input module or an
additional CVBS (MAV-1) input module.
Section 3: Technical Information
