Notices
F.
Routing and terminating coaxial cable(s)
D.
Route the coaxial cables to the radio equipment, taking care to avoid running them adjacent to any existing wir-
ing or fouling any moving components. Be careful to observe the cable bend radius of 25mm (1”) for the B4BE/
LPB and 12mm (1/2”) for the LPBE.
Commission and test
E.
Check the comms cables:
• Carry out VSWR check, the VSWR should measure <2.5:1 in transmit band.
• Connect the Cellular/LTE cable.
European Waste Electronic Equipment
Directive 2002/96/EC
Waste electrical products should not be disposed of with household waste. All electronic prod-
ucts with the WEEE logo must be collected and sent to approved operators for safe disposal or
recycling. Please recycle where facilities exist. Many electrical/electronic equipment retailers
facilitate “Distributor Take-Back scheme”for household WEEE. Check with your Local Authority or
electronic retailers for designated collection facilities where WEEE can be disposed of for free.
DO NOT
• operate the transmitter when someone is within 20cm (8”) of the antenna.
• operate the equipment in an explosive atmosphere.
• attempt to install the antennas without the proper safe equipment to access the install
location.
• install the antenna in such a way that it may fall and cause injury.
• install the antenna near overhead power lines
• chew parts or put them in mouth, keep away from unsupervised children.
Directive 2011/65/EU (RoHS 2)
RoHS 2
compliance is declared per Directive 2011/65/EU and its subsequent amendments
with exemption 6.c applied.
REACH
(Registration, Evaluation, Authorisation and Restriction of Chemicals, EC 1907/2006)
This product contains Lead (CAS No. 7439-92-1) which is classifi ed as an SVHC (Substance of
Very High Concern) as being toxic to reproduction under Article 57c. of REACH.
Do not chew
parts or put them in mouth, keep away from unsupervised children. Dispose of parts
as WEEE waste do not send to landfi ll.
Waiver:
This document represents information compiled to the best of our present knowledge. It is not intended as a representation or
warranty of fi tness of the products described for any particular purpose. This document details guidelines for general information purposes
only. Always seek specialist advice when planning installations.
