BA_PH_245-100-300_EN_06-22.docx
51
16.6
Extendable Frame Support
Figure 50: Clamping lever for extendable frame support
The table top with dimensions 1100 x 760 mm
can optionally be equipped with an extendable
frame support (instead of the rigid standard
frame support).
•
Toral length approx. 1375 mm
•
Extension depth approx. from the centre
of the milling spindle.
•
Guided in separate bearing blocks at the
side of the machine table.
The table is clamped by means of the two star
grips (
K
) which are located on the left and right
side of the table below the extension rods.
The article number, table extensions and other table systems can be found in section
20.2 “Table Systems“.
16.7
TM 300 - RFID based Machine Access Control System
Figure 51: TM-300 Machine Access Control System
The TM 300 key system offers the highest level
of security. With the user data bank, only au-
thorised personnel can start the machine by
using a personalised RFID key.
Included is the TM 300 system with 5 person-
alised user keys and 1 full access key for au-
thorised and instructed persons.
With the red master key, parameter settings
and staff instructions can be carried out. The
five blue RFID chips serve as user keys for the
machine operators. Additional user keys can
be ordered optionally.
The article numbers of the system and supplementary accessories are listed in section
16.8
Calibration Unit “Zeromaster”
Figure 52: Calibration unit “Zeromaster”
With the Zeromaster it is possible to measure
the effective cutter height and to reference
the machine incrementally to this value. This is
very helpful to calibrate the tool height or the
zero point of the tool quickly and easily.
The operation is done via the touchscreen con-
trol unit. The exact procedure is described in
the
BA_PH_UT300_EN
operating manual.
The article number can be found in the section
20.1 “Technical Extensions”.
K