BA_PH_245-100-300_EN_06-22.docx
40
14.2.2
Fence Type 302
Figure 30: Operating elements Fence Type 302
With type 302, the total and partial fence
are manually adjustable.
To adjust the complete
fence, release
the two quick-release levers (
3
) and (
6
)
and adjust the fence via handwheel (
2
)
and/or (
5
).
Afterwards, the two quick-release levers
must be re-tightened.
The digital handwheels (
2
) and (
5
) are
each equipped with a position indicator.
The actual positions of the total and par-
tial fence are additionally visualised on
the touchscreen of the control unit.
Pos. Description
Pos. Description
1
Total fence plate
7
Splinter tabs
2
Total fence handwheel adjustment
8
Clamping for fence plate adjustment
3
Total fence quick-release lever
9
Sliding covers for high tools
4
Partial fence plate
10
Knurled screws for tool covers (
9
)
5
Partial fence adjusting screw
11
Milling protection & pressure device (folded up)
6
Partial fence quick-release lever
12
Protective hood (unlocking rear left)
Fence plate adjustment
Loosen the star grip (
8
) and push the fence plate (
1
) to the desired position. Then retighten the star grip (
8
). Al-
ways adjust the plates so that they cover as much of the tool as possible without touching it.
Folding up the protective hood
Before the protective cover (
12
) of the fence can be folded up, the
locking bolt (
V
) at the rear left must be unlocked by pressing it in
(see
Fit a grooved board or safety rulers
To insert a grooved board or safety rulers, remove the splinter tabs
(
7
), attach the grooved board or safety rulers as fence bridges and
fasten them via the free threaded holes.
Figure 31: Locking bolt of Type 302
Tool covers for high milling arbors
By opening the knurled screws (
10
), the two cover plates can be moved, which is particularly advantageous with
high milling arbours. The opening should always be closed as far as possible without touching the milling arbor
or the cutter.
11
To adjust the right (partial) fence plate, only the right quick-release lever (
6
) has to be loosened.
12
The two star grips (
8
) for the fence plates are located on the rear side.
5
2
4
1
3
6
7
8
10
9
11
12
V