BA_PH_690-100_EN_10-22.docx
16
Be aware of the risk of crushing between the slide table and the holding block for the saw blade.
Be aware of the risk of crushing at the end of the running rail for the slide table between the run-
ning rail and the slide table.
Pay attention to the risk of crushing on the inside of the slide table on fixed components / guide rail
(2x) on the inside of the slide table.
Be aware of the risk of crushing when pushing the slide table forward between the slide table and
the front holding block for the saw blade.
Do not stand between the cross-cut fence and the telescopic swivel arm (when pushing the slide
table forwards or backwards). There is a danger of crushing (it is forbidden for the operator and
third persons to stay in this area).
Pay attention to the danger of crushing in the area of the support for the cross slide (at the swivel
arm). Reaching into this area is prohibited!
Do not reach into the area between the rip fence and the ruler bar
(especially when pushing back the rip fence).
Pay attention to the danger of cutting and crushing in the area of the scoring saw blade. Access
during normal operation and by unauthorised persons is strictly prohibited.
Make sure that you do not reach into the area of the rotation angle limiters on the underside of the
upper guide arm for the saw blade guard. There is a risk of crushing there.
Make sure that no unauthorised persons are in the area of the machine.
Be aware of the risk of crushing between the sliding cross-cut fence and the cross slide on both
sides: Do not reach into these areas!
Before telescoping the cross-cut fence, make sure that the main element is fixed in place using the
two black star wheels.
Be aware of the danger of crushing between the telescopic extendable part of the cross-cut fence
and the end piece of the scale.
The emergency stop buttons must always be freely accessible. They must not be moved, e.g. with
hopper boxes. Check the function of the emergency stop buttons daily (before starting work).
Laser warning: The machine can be optionally equipped with a laser pointer for the cut position.
Looking directly into the laser beam will cause serious eye injury!
Fire hazard due to wood dust in connection with flying sparks and/or open fire!
4.1.4
Observe the Environmental Protection Regulations
During all work with the machine, the environmental protection regulations, obligations and laws for waste
avoidance and proper recycling and/or disposal applicable at the place of use must be observed. This applies in
particular to installation, repair and maintenance work involving substances that could pollute the groundwa-
ter (e.g. hydraulic oils and cleaning agents and liquids containing solvents). In any case, prevent them from
seeping into the ground or entering the sewage system.
Store and transport the above-mentioned hazardous substances only in suitable
containers. Avoid leakage of hazardous substances by using suitable collection con-
tainers. Ensure that the above-mentioned substances are disposed of by a qualified
disposal company.
