9910048 RevC
February 2020
PAGE
14
Lock Claw Insertion Gauge configuration and use
Place gauge against Lock Claw and underside
of module.
Select a Lock Claw which has been
confirmed to be installed correctly
through visual inspection.
The Tilt Arm and Lock Claw should
be aligned with the module frame
and the Lock Claw fully engaged
on the frame.
Note:
The images shown here are
generic and are applicable across
the entire cFR platform.
Mark line on gauge to finish setup.
Use gauge to confirm full Lock Claw
engagement-line must be visible.
9. Cam & Lock Claw Inspection
Inspect Cam side module connection
Cam installation can be quickly
visually inspected (no gauge is
available or required) by
comparing a known good
installation with all other
installations.
Some gap between Module and
Cam is permissible.
ALERT:
A known good installation
can be verified by lifting up on the
module near the Cam. When you
attempt to lift, no movement will
occur.
Module and Cam are near flush.
Module and Cam have a large
non-uniform gap.
