V00028CA Rev03
www.panduit.com
Page
14
of
18
d.
Remove the pre-installed Fiber Bend Radius Control Clips from the front of the enclosure. This allows
the inner drawer to be pulled back towards the rear of the enclosure.
e.
Remove the cable entry grommet from the rear of the fiber enclosure.
f.
Route the jacketed fiber through cable entry grommet.
g.
Remove approximately 39” of the fiber jacket exposing the buffered fiber inside.
h.
Field-terminate the required fiber adapters onto the fiber.
i.
Re-insert the grommet back into the Fiber Enclosure.
j.
Route the Fiber Cable as shown in
. The fiber entry for this application is on the right side of
the enclosure. Use Tak-Ty to secure fiber cords at the cable entry location and other points as shown.
k.
Route the buffered fiber around the spools as shown.
l.
Insert the fiber connectors into the desired pre-installed fiber adapter panel (FAP) locations in the
enclosure. Note that the FAPs can be easily removed via push pull latches on the faceplates.
Figure 17: FRME1U Fiber Enclosure Cable Routing
