For Technical Support:
http://www.panduit.com/wcs/Satellite?pagename=PG_Wrapper&friendlyurl=/en/support/con
tact-us
INSTALLATION INSTRUCTIONS
© Panduit Corp. 2014
V00028RH
Z11C-**
Preconfigured Network Zone System Z11C-** configurations include an enclosure and cable
management.
Be sure wall is capable of supporting cabinet and equipment.
DISCLAIMER OF WARRANTIES AND LIMITATION OF LIABILITIES
The practices contained herein are designed as a guide for use by persons having technical skill at their own discretion and risk. Panduit
does not guarantee any favorable results or assume any liability in connection with these instructions. Local, State, Federal, and Industry
Codes and Regulations, as well as manufacturers requirements, must be consulted before proceeding with any project. Panduit Corp.
makes no representations of nor assumes any responsibility for the accuracy or completeness set forth herein.
Panduit disclaims any liability arising from any information contained herein or for the absence of same.
Page 3 of 8
SAFETY INFORMATION
The information and instructions contained in this document are not intended to be utilized as a substitute for proper training and
experience in the safe installation and operation of product. Prior to installation, it is the Buyer’s responsibility to consult with the
appropriate local Authority Having Jurisdiction (AHJ) for all applicable codes, permits, regulations and standards.
This product, including any equipment that may be installed inside, should only be installed and serviced by a licensed electrical
contractor, or competent technician, that meets the following qualifications;
·
Is thoroughly familiar with this product and the instructions for installation and operation
·
Is trained (accredited) in industry-accepted safe operating practices and procedures regarding identification and mitigation of
high- and low- voltage hazards and situations.
·
Is trained to identify and install appropriately-sized Branch Circuit Disconnect(s) with appropriately-sized Branch-Circuit
Protective Rating and Short-Circuit Current Rating (SCCR), before connecting Panduit product to the branch circuit.
·
Is trained and authorized to energize, de-energize, clear and ground power distribution equipment.
Is trained in the care and use of appropriate PPE (personal protective equipment) including, but not limited to; arc-flash protective cloth-
ing, safety glasses, face shield, hard hat, gloves and non-conductive tools (clamp stick, hot stick, etc.).