INSTALLATION INSTRUCTIONS CM361C
For Technical Support: www.panduit.com/resources/install_maintain.asp
Page 2 of 8
Install in Ceiling
Install (4) threaded rods to the building structure. The threaded rod must
be attached on all four corners of the enclosure with a nut and washer
above and below the support bracket. Level the enclosure so the weight
is not supported by the ceiling grid system.
Ceiling Tile Cutout
Place the included ceiling tile cutout template over
the removed ceiling tile. Secure the template with
tape of thumb tacks. Trace the outline with a utility
knife to extract the necessary shape to insert into
the enclosure.
While the enclosure is installed in the ceiling and open, remove the (3) #6-32 screws and ceiling tile bracket as shown below. Once
removed, slide the ceiling tile cutout into place fitting around the fan module. After proper orientation is achieved, replace the ceiling tile
bracket and the (3) #6-32 screws back into enclosure.
Insert Ceiling Tile Cutout into Housing
#6-32
Screws
Ceiling Tile
Bracket
Ceiling Tile
Cutout
Ceiling Tile
Ceiling Tile
Template
Thumb Tacks
