INSTALLATION INSTRUCTIONS CM296A
For Technical Support: www.panduit.com/resources/install_maintain.asp
Page 3 of 5
4
4.1 Refer to the power supply instruction sheet for proper
wiring techniques and safety.
4.2 Run a lead from the outside "+" position on the output
side of the power supply to the 1 position of the
thermostat.
4.3 Run the positive lead of the fan to the 2 position of the
thermostat.
4.4 Run the negative lead of the fan to the outside " - "
position on the output side of the power supply.
4.5 Use the adhesive mounts and P
AN
-T
YS
to manage the
wires and secure them to the inner panel. Save a
couple adhesive mounts and P
AN
-T
YS
to manage and
secure the incoming power lines to the inner panel.
Step 4: Wiring Optional Thermostat and Fan
5.1 Refer to the power supply instruction sheet for proper
wiring techniques and safety. If the power supply is not
being connected to the incoming power at this time,
cover the hole using the provided Electrical Hole Seal.
5.2 Connect the hot wire to the "L" on the input side of the
power supply.
5.3 Connect the neutral wire to the "N" on the input side of
the power supply.
5
Step 5: Wiring the Input Side of Power Supply
