CT-980
CT-980: PA25182A01_01
Page: 5 of 7
12-2011
1. Verify that the open areas between the indenters in tool head are free of foreign matter and debris
that could jam or damage the tool during operation.
2. Verify the proper size connector for the conductor, by checking product packaging, Panduit catalog or
website.
NOTE: CONNECTIONS UTILIZING THIS TOOL ARE U.L. LISTED AND C.S.A. CERTIFIED ONLY
WHEN PANDUIT COPPER COMPRESSION CONNECTORS ARE USED.
USE OF ANY OTHER BRAND OF COMPRESSION CONNECTORS IS NOT RECOMMENDED.
3. Verify that the hinged tool top is locked in the closed position with the lockout pin (see Fig. 2 on Page
5). Carefully position the connector against the stationary indenter in the hinged tool top.
4. With the tool supported, pump the top handle to initiate rapid advance of the indenters toward the
connector. Stop pumping immediately when the indenters contact the connector.
5. Verify that the connector matches the conductor size. Insert the conductor completely into the
connector barrel.
NOTE: For number of crimps needed, refer to product packaging, Panduit catalog or website.
6. Verify connector placement as shown in Fig. 4 on Page 6.
CAUTION
Before crimping a connection, verify that the tool top
on the tool head is locked in the closed position.
The lockout pin must be engaged completely
through the tool head and both surfaces of the
tool top.
Fig. 2
Fig. 3
