CT-930
CT-930: PA25202A01_01
Page: 4 of 7
5-2012
CAUTION
1.
Do not operate tool without dies and connector in position. Operation without dies and connector will
result in fracture or distortion of the head or ram. If the tool ram is inadvertently closed without the dies
or connector, do not continue to apply pressure by further pumping. Loosen the M8 screw (see Fig. 2
on Page 6) to release the pressure.
2.
Be sure to select appropriate dies to suit the terminal to be crimped. Improper combinations result
in inferior connections of conductors.
Consult product packaging, Panduit catalog or website for part numbers and specific die
application information.
NOTE: DIES ARE DESIGNED TO PRODUCE THE HIGHEST QUALITY CONNECTIONS WITH
PANDUIT CONNECTORS. CONNECTIONS UTILIZING THIS TOOL ARE U.L. LISTED AND
C.S.A. CERTIFIED ONLY WHEN PANDUIT COMPRESSION CONNECTORS ARE USED. USE
OF ANY OTHER BRAND OF COMPRESSION CONNECTORS IS NOT RECOMMENDED.
3.
Re-calibrate the tool as instructed in the Tool Force Inspection / Calibration section on Page 7.
DIE SELECTION
Match the die color code and die index number on the crimp die to the color code and die index number
marked on the compression connector (see Fig. 1 on Page 4).
DIE IDENTIFICATION FOR USE WITH MATCHED CONNECTOR
Fig. 1
