AT-OME-PS62
30
webGUI
RS-232 Parameter Setting
Console
- Select the baud rate, data bit, parity, and stop bit to match the control system’s parameters. Defaults
are 115200, 8, None, and 1.
HDBaseT In 1
- Select the baud rate, data bit, parity, and stop bit that will be sent from the HDBaseT IN port
to the connected HDBaseT transmitter. This should be set to match the source device being controlled by the
transmitter. Defaults are 115200, 8, None, and 1.
HDBaseT In 2
- Select the baud rate, data bit, parity, and stop bit that will be sent from the HDBaseT IN port
to the connected HDBaseT transmitter. This should be set to match the source device being controlled by the
transmitter. Defaults are 115200, 8, None, and 1.
HDBaseT Out
- Select the baud rate, data bit, parity, and stop bit that will be sent from the HDBaseT OUT port
to the connected HDBaseT receiver. This should be set to match the source device being controlled by the
receiver. Defaults are 115200, 8, None, and 1.
RS-232
Select RS-232 from the top navigation to adjust the parameters of the RS-232 ports.