Panduit Atlona Omega AT-OME-EX-TX-WP-E Series, Руководство по установке

Страница: 3 / 16

3
Installation Guide
AT-OME-EX-TX-WP-E
1. Use wire strippers to remove a portion of the RS-232 cable jacket.
2. Remove at least 3/16” (5 mm) from the insulation of the RX, TX, and GND wires.
3. Insert the TX, RX, and GND wires into correct terminal using the included 3-pin captive
screw connector.
4. Connect the opposite end of the cable to the control system.
NOTE: Typical DE-9 connectors use pin 2 for TX, pin 3 for RX, and pin 5 for
ground. On some devices functions of pins 2 and 3 are reversed.
RS-232
GND
RX
TX
DE-9 (RS-232) port
The AT-OME-EX-TX-WP-E provides an RS-232 port which allows communication between a
control system and an RS-232 device. This step is optional.
OMEGA
TM
AT-OME-EX-TX-WP-EU
HDMI HUB
LINK
PWR
HOST
RS-232
RXTX
HDBaseT OUT
RS-232 port on back of unit