Panduit Atlona AT-HDR-EX-70C-KIT, Руководство по установке

Страница: 6 / 12

6
Installation Guide
AT-HDR-EX-70C-KIT
Mode 1: Link
This is the default position of the dial and puts the unit into normal operation.
Mode 2: FW
This mode sets the transmitter into firmware updating mode. View Firmware Updating
instructions on the next page for manual updating.
DC 48V
- +
RS-232
RX TX S S
HDBaseT OUT HDMI IN IR OUT IR IN
AT-HDR-EX-70C-TX
POWER
LINK TEST UTILITY
1. LINK
2. FW
3. TEST
4. 5V LOCK
UTILITY
The utility port and dial are used for updating firmware and 5V
lock. Use the Dial to switch between modes.
Mode 3: TEST
Not used. Refer to the TEST button procedure, on page 5.
Mode 4: 5V Lock
This mode sets the +5V and the HPD signal of the transmitter and receiver to high. This allows
the source and display to have a consistent connection, even if there are issues with the source
and display signals.