The description below makes references to Table 5.
Mode 1: Manual Clipping
Set switch 6 to Manual. Set switch 4 to Install. Push button1 to do the clipping operation. Push
button 2 to retract the arms of the work head. This mode is used when the operator is setting up
the machine or for some other reason want to do a manual operation.
Mode 2: Manual De-clipping
Set switch 6 to Manual. Set switch 4 to Extract. Push button 2 to do the de-clipping operation.
Push button 1 to retract the arms of the work head. This mode is used when the operator is
setting up the machine or for some other reason want to do a manual operation.
Mode 3: Auto Clipping
Set switch 6 to Auto. Set switch 4 to Install. Push button 1 to start the clipping cycle, release the
button immediately. The retraction of the arms of the work head is done automatically. This mode
is used for normal clipping operation.
Mode 4: Auto De-clipping
Set switch 6 to Auto. Set switch 4 to Extract. Push button 2 to start the de-clipping cycle, release
the button immediately. The retraction of the arms of the work head is done automatically. This
mode is used for normal de-clipping operation.
The dead-mans-handle needs to be pressed in towards the handlebar at all normal use. This
allows the machine to rest on the jockey wheel. If the handle is released, the machine sinks down
on the ground to prevent runaway on track or to allow for sleeper lifting (see chapter 6.1.3 for
sleeper lifting procedure).
The battery switch shall always be turned off when leaving the machine (see Fig. 8).
Battery switch
Fig. 8
Doc id: ENG_OMM_CD200_P05
16/52
© Pandrol AB
