NOTE!
•
When operating a 10 GPM tool you cannot have any other tool connected to
the 5 GPM ports, even if the tool is not being used.
5. Operation
•
With the power source in the "OFF" position, connect the hoses. Do not drag the service hose by pulling
with the tool. Loop the service hose in the work area in such a way to relieve stress on the hose and quick
disconnect fittings while working. Be aware of hose location at all times.
•
Connect the bridge spreader to the power source.
•
Turn the power source "ON" to supply 5 GPM to bridge spreader.
•
Pull the control lever back to raise the bridge spreader.
•
Once bridge spreader has raised bridge sufficient enough to remove cap power source can be disconnected
without bridge falling.
•
Once work has been completed, connect bridge spreader back to power source and push control lever forward
to lower bridge back on cap.
•
Turn the power source "OFF" before disconnecting bridge spreader.
8 av 26
OPERATION AND MAINTENANCE MANUAL I ENG_OMM_BRIDGE_SPREADER_P01 I 02th December 2021
@Pandrol 2021
