2
Storage, Issue & Inspection
Storage
Storage in a centrally located protected area allows the assurance of inspection on issue and return. This
harness should be stored in a clean dry place where it can be protected from damage by chemical attack,
sharp objects, heat and direct sunlight. It should be stored with its instructions and record card at all times. If
the harness is wet, ensure it is left to dry naturally before storage. After use return to the store, never leave
a harness lying around site.
Issue
This harness and associated equipment must be visually inspected by a competent person when first delivered
to site, thereafter check your harness and associated equipment for any damage or malfunction prior to each
and every use. If there is any doubt about the safe condition of the system, it should be immediately withdrawn
from use and inspected by a competent person or returned to the supplier/manufacturer.
The product name, unique serial number and date of manufacture will be found on the product label.
Always ensure the product label is present, shows both the serial number and date of manufacture and that it
matches your inspection Record Document/this manual. If the Product Label numbers are not legible or do
not match your inspection record document/this manual – Do not use the harness.
Detailed Recorded Inspections at a frequency of 6 months should only be carried out by a competent person,
appointed by the employer. Additional, recorded interim inspections may be required where risks from
transient arduous working conditions exist. This should be identified through risk assessment.
Inspection
Webbing - ensure that the webbing is free from cuts, abrasion, wear and tears. Special attention should be
given to the webbing under each and every buckle for rubbing and general deterioration. Check that the
weave of the webbing is even and shows no sign of distortion or “necking” resulting from loading.
Buckles - check for damage, distortion. Surface coating should be clean and show no sign of corrosion.
Sewing - Look for loose or damaged threads and uneven stitch pattern.
if any feature shows cause for concern remove the unit from service immediately, mark the harness as
unserviceable and return to the supervisor.
No repairs, modifications or alterations are to be carried out on this P&P Full Body Sit Harness.
Environmental Hazards
This product is manufactured from polyester throughout and is therefore susceptible to wear, abrasion, cuts,
melting and chemical attack. Always inspect the full length of the webbing before and after use. In environments
where acids, alkalies, phenolic compounds, and heat are present special care should be taken when inspecting
the integrity of the webbing.
Cleaning
Clean equipment regularly with a mild detergent and water, allow to dry naturally. A clean harness is easier to
inspect and will last longer.
Front Suspension “D”
Attachments for CROLL
Work Positioning Side “D”
Leg Loops
Attachment for
Suspension Seat
Waist Belt
Click Lock Buckle
Elasticated Strap Holder
Leather Neck Protector
Adjustable Rear Leg Extensions
(not visible)
Shoulder Adjustment
Rear Fall Arrest “D” (not visible)
Shoulder Straps
Front Fall Arrest “D”
Leg Adjuster & Click Lock Buckle
