67
Program DOWN
--- If ≥64 then the program number first steps
down by one, then it starts scrolling (as
when holding the Program footswitch). If
<64 then it stops again.
69
FI ON/OFF toggle
--- If ≥64 then the FI flips between ON and
OFF. If <64 then the message is ignored.
(If the Tuner is active then sending this
message will disengage the Tuner and put
the FI into the OFF state.)
74
Filter cutoff
64 Deviates ±1, ±2 or ±4 octaves from the
cutoff value set by the VCF FRQ slider in
the program. Range is set by
VCF
CONTROL RANGE
in the
88
Program UP /
Tap Tempo input
--- For Program UP, if ≥64 then the program
number first steps up by one, then it starts
scrolling (like when holding the Program
footswitch). If <64 then scrolling stops
again.
When the Tuner is engaged then values of
≥64 send a tap to the
function.
If <64 then the message is ignored.
89
Tuner ON/OFF toggle /
Tap Tempo entry mode
ON/OFF toggle
--- If ≥64 then the Tuner flips between ON
and OFF. If <64 then the message is
ignored.
Whenever the Tuner is disengaged, the FI
reverts to the ON state (just as using the
ON/OFF footswitch does). (CCs 66 and 69
will also disengage the Tuner. See above.)
90
Bank UP
--- If ≥64 then the bank number steps up by
1. If <64 then the message is ignored.
91
Bank DOWN
--- If ≥64 then the bank number steps down
by 1. If <64 then the message is ignored.
92
INSTR volume of Main
Mixer
127 When at maximum (127) the INSTR
volume corresponds to the preset value in
the program.
This is logarithmic and
before
the Effects
Block, so delay trails etc. are
not
muted
when CC92 is at 0.
79
Содержание Future Impact v3
