message
meaning
message meaning and possible solutions
System?
English
English / Metric unit selection.
Press R and use the
[up] or
[down] buttons to select.
LOW BATT
Battery is 21v or lower. Camera will continue to function, but may
not run correctly at higher than 40FPS.
Replace weak battery with a fully charged battery.
FILM JAM
Film jammed in movement. Camera will not run.
Open the door and clear the jam.
FILM LOW
Film magazine is near empty.
For indication only
FILM OUT
Film magazine is empty, and camera stops.
Reload with new film and push “R” button on the Control Panel to
reset footage counter.
DOOR
Camera door is open, and camera will not run.
Check that door is securely latched.
ILLEGAL
SETTING
FPS or shutter angle entry is not valid, or outside of specification.
Re-enter the desired speed or shutter value.
FILTER
A behind-the-lens filter is in use.
For indication only
PHASE
OUT
Camera is in movement/shutter phase-out mode (i.e. for streaking
effect).
Push “PHASE” button once to get back to normal mode if desired.
NORMAL
Camera is not in phase-out mode.
Push “PHASE” button once to get back to phase-out mode if
desired.
Display blank or
cycling on/off.
Battery is probably bad.
Try a known good battery.
FTZ BAD
One of the FTZ motor drivers is damaged, or bad connection at the
connectors. Camera will run normally, but the front face FTZ motor
drivers may be disabled.
Contact Panavision
USE HTR
Camera internal temp is below 50°F or 10°C.
Connect 24v battery to camera heater connector. The amber LED
will light up while heater circuit is on.
Camera ?
4 perf
4 perf / 3 perf / 2 perf selection.
Press R and use the
[up] or
[down] buttons to select.
XL2 Ver
116
Camera software version
Cpu
035
CPU software version
Dsp1
005
DSP1 software version
Dsp2
030
DSP2 software version
Xilinx
013
Xilinx software version
Epan
008
Epan software version
Magazine
043
Magazine software version
Panel
025
Control Panel software version
Display
012
Display [removable butterfly]
software version
Additional modes are accessed by pushing the DOWN
button while
powering up the camera. Press M to cycle to the next mode. Cycling camera
power exits these modes and returns to normal operation.
XL2 DISPLAY MODES
XL2 WARNING MESSAGES
