[Multicast address]
Enter the multicast IP address. Images will be transmitted to the designated IP address.
•
Available IPv4 address:
224.0.0.0 - 239.255.255.255
•
Available IPv6 address:
Multicast address starting with “FF”
•
Default:
–
Stream(1): 239.192.0.20
–
Stream(2): 239.192.0.21
–
Stream(3): 239.192.0.22
Note
•
Enter a multicast IP address after checking available multicast address.
[Multicast port]
Enter the multicast port number (used to transmit images from the camera).
•
Available port number:
1024 - 50000 (Only even numbers are available.)
•
Default:
37004
[Multicast TTL/HOPLimit]
Enter a value for “Multicast TTL/HOPLimit”.
•
Available value:
1-254
•
Default:
16
IMPORTANT
•
When transmitting stream images via the internet, the transmitted image sometimes may not be
displayed depending on the settings of a proxy server or a firewall. In this case, refer to the network
administrator.
•
When two or more network interface cards are installed on the PC in use, the network interface
card(s) not used for receiving images should be invalidated when displaying images using the multicast
port.
*1
It is necessary to designate the unicast port number when “Unicast port (MANUAL)” is selected for “Transmission type”.
*2
It is necessary to designate the multicast IP address when “Multicast” is selected for “Transmission type”.
Operating Instructions
71
2 Settings
