![background image](http://html.mh-extra.com/html/panasonic/wv-s4150/wv-s4150_important-information-manual_277952013.webp)
13
In order to prevent injury, the product
must be securely mounted to a wall or
ceiling according to Installation Guide.
Power supply
This product has no power switch.
When performing electrical work, make sure the
camera can be turned on and off. When an
Ethernet cable or power cable is connected, the
power is turned on. When cleaning the product,
remove the Ethernet cable or disconnect the
power cable from the main power supply.
Installation area for this product
Select an appropriate place for the installation
area (such as a strong wall or ceiling) in your
particular environment.
• Make sure that the installation area is
strong enough to hold this product, such
as a concrete ceiling.
• Install the camera in the foundation area of
the architecture or where sufficient strength
is assured.
• Do not mount the product on a plaster
board or a wooden section because they
are too weak. If the product is unavoidably
mounted on such a section, the section
shall be sufficiently reinforced.
Install the product in areas that do not
receive direct sunlight.
Do not place this product in the following
places:
• Locations where a chemical agent is used
such as a swimming pool
• Locations subject to moisture or oil smoke
such as a kitchen
• Locations that have a specific environment
that is subject to an inflammable atmo-
sphere or solvents
• Locations where a radiation, an X-ray, a
strong radio wave or a strong magnetic
field is generated
• Locations near coasts directly subjected to
sea breezes, or locations subject to corro-
sive gases such as from hot springs, vol-
canic regions, etc.
• Locations where the temperature is not
within the specified range (
☞
page 25)
• Locations subject to vibrations that exceed
the railway specifications (EN50155)
• Locations subject to condensation as the
result of severe changes in temperature (In
case of installing the product in such loca-
tions, the dome cover may become foggy
or condensation may be caused on the
cover.)
Sulfurization caused by rubber products
Do not place the product near rubber products
(packing, rubber feet, etc.) that contain sulfur.
There is a risk that sulfur components in rubber
products may cause electrical parts and termi-
nals, etc. to become sulfurized and corrode.
Screw tightening
• The screws and bolts must be tightened
with an appropriate tightening torque
according to the material and strength of
the installation area.
• Do not use an impact driver. Use of an
impact driver may damage the screws or
cause tightening excessively.
• When a screw is tightened, make the
screw at a right angle to the surface. After
tightening the screws or bolts, perform
checks to ensure that the tightening is
sufficient enough so that there is no
movement or looseness.
Panasonic assumes no responsibility for injuries or property damage resulting from
failures arising out of improper installation or operation inconsistent with this
documentation.
For information about the installation tasks, refer to the provided Installation Guide.
Precautions for installation