Panasonic WV-Q122E, Руководство по эксплуатации

Страница: 2 / 8

-2-
Front Cable Exit
1. Preparations
Specify the bracket fixing location, and then put in
four anchor bolts, or drill four bolt holes on the
installation surface. Refer to
Dimensions on page 7.
2. Cable Bushing
Fit the supplied cable bushing into the front cable
exit of the bracket.
3. Cable Route
Route the connection cables from the front cable
exit through the bracket, and pull them out of the
pipe mouth.
4. Fixing Bracket
Fix the bracket to the wall using appropriate hard-
ware (not supplied): bolts and nuts, anchor bolts
and nuts, or the like.
Mark hole positions
Cable Bushing
Fixing Hardware
(Locally Procured)
■
Introduction
This bracket is used for mounting the colour camera WV-CW960 or WV-CW964 onto a wall.
There are two ways of cable exit available from the front or rear of the bracket.
Precautions
• Make sure that the place you are installing the camera is strong enough to support it. If it is not strong enough, then the cam-
era may fall and hurt someone.
• The following steps of installation and connection work should be done by qualified service personnel or system installers
and should conform to all local codes.
• Be sure to turn the power off before installation and connection.
• Do not install the camera near the air outlet of an air conditioner.