Panasonic WV-Q122AS, Руководство по эксплуатации

Страница: 10 / 16

10
Step 2
Mount the cable cap (accessory) on the cable access hole
(front).
Step 3
Make a slit in the center of another cable cap (accessory)
with a cutter.
Step 4
Remove the 4 screws from the rear side of the bracket,
remove the plate, and mount the cable cap that was slit in
Step 3.
Step 1
Decide the mounting position, and drill a hole for a screw or
an anchor and a hole for cable installation in the wall.
Procure 4 pieces of M10 screws and anchors to secure the
this bracket on the wall.
For screw and anchor, make sure to use the one made of
stainless steel, and enough salt damage prevention is
applied. The hole diameter shall be decided in accordance
with the screws and anchors to be used.
A hole on the wall with a diameter of 30 mm {ø 1-3/16
inches} or less for a screw or an anchor can be hidden with
this bracket.
■
When laying cables after drilling a hole through the wall
Hole for cable
installation: ø38 mm
{ø1-1/2 inches}
80 mm
{3-5/32 inches}
120 mm
{4-3/4 inches}
180 mm
{7-3/32
inches}