10
[Precautions for use]
This product has no power switch.
Turn the power off when cleaning the product.
To keep on using with stable performance
Parts of this product may deteriorate and it
may shorten the lifetime of this product when
using in locations subject to high temperatures
and high humidity.
Do not expose this product to direct heat
sources such as a heater.
Handle this product with care.
Do not abuse this product. Avoid striking,
shaking, etc. The product could be damaged
by improper handling or storage. If a strong
shock or vibration is applied to the enclosure, it
may cause damage or allow water to enter this
product.
Do not touch the dome cover with your
bare hands.
A dirty dome cover causes deterioration of pic-
ture quality.
Discoloration on the CCD color filter
When continuously shooting a bright light
source such as a spotlight, the color filter of
the CCD may have deteriorated and it may
cause discoloration. Even when changing the
fixed shooting direction after continuously
shooting a spotlight for a certain period, the
discoloration may remain.
Do not aim this product at strong light
sources.
A light source such as a spot light causes a
blooming (light bleeding) or a smear (vertical
lines).
Cleaning this product body
Turn the power off when cleaning the product.
Do not use strong abrasive detergent when
cleaning this product. Otherwise, it may cause
discoloration. When using a chemical cloth for
cleaning, read the caution provided with the
chemical cloth product.
To remove stubborn stains
When the dirt is hard to remove, use a mild
detergent and wipe gently. Then, wipe off the
remaining detergent with a dry cloth.
What to do if
"
OVER HEAT" appears on the
display
This message indicates that the inside of the
camera has become extremely hot. Immediate-
ly turn off the power of the camera and contact
your dealer.
What to do if "WARMING UP-PLEASE
WAIT" appears on the display
*
This message indicates that the temperature
inside the camera has become extremely low.
In such a case, wait until the heater unit
(option) raises the internal temperature (for
around 2 hours or more in low temperatures
below –10 °C), and turn on the power again.
* To ensure this function works normally, the
heater unit (option) is required.
What to do if "CAMERA TEMP. TOO COLD.
POWER ON AT -30 DEG C (-22 DEG F) OR
MORE." appears on the display
The ambient temperature is too cold.
Please turn on the power under the conditions
where the ambient temperature is above -30 °C.
Smear
Blight subject
Blooming
