15
Preparations
When installing the camera on a wall or a ceiling, there are two methods as specified below.
(
+
Next page)
• Using a two-gang junction box (locally procured)
• Using the camera mount bracket (accessory)
Refer to all work related to the installation of this product to qualified service personnel or system
installer.
Important:
• Prepare the mounting screw according to the material of the area where the attachment plate
(accessory) is to be installed. In this case, wood screws and nails should not be used. For
mounting a camera on a concrete ceiling, use an anchor bolt (M4) or an AY plug bolt (M4) for
securing.
(Recommended tightening torque M4: 1.6 N·m)
• Required pull-out capacity of a single screw/bolt is 196 N or more.
• If a ceiling board such as plaster board is too weak to support the total weight, the area shall
be sufficiently reinforced.
• When using an optional mount bracket, refer to the operating instructions of the bracket in use.
The mounting conditions of the camera mount bracket are described as follows:
Installation
place
Applicable mount
bracket
Recommended
screw
Number
of screw
Minimum pull-out
strength
(per 1 pc.)
Ceiling/wall
Two-gang junction box
(locally procured)
M4 or equivalent
4 pcs.
196 N
Ceiling/wall
Camera mount bracket
M4 or equivalent
4 pcs.
196 N
Ceiling/wall
Optional mount brackets
(Refer to page 40)
–
–
*
* Make sure that the installed mount bracket can support more than 5 times of the total weight of
the camera, attachment plate and screws.
