Panasonic WV-CP300 Series, Руководство по установке

Страница: 10 / 32

10
Precautions for installation
Panasonic assumes no responsibility for
injuries or property damage resulting from
failures arising out of improper installation
or operation inconsistent with this docu-
mentation.
This product is designed to be used
indoors.
This product is not operable outdoors.
Do not expose the product to direct sunlight
for hours and do not install the product near a
heater or an air conditioner. Otherwise, it may
cause deformation, discoloration and mal-
function. Keep the product away from water
and moisture.
Installing place
Contact your dealer for assistance if you are
unsure of an appropriate place in your particu-
lar environment.
• Make sure that the installation area is strong
enough to hold the product, such as a con-
crete ceiling.
• Install the camera in the foundation area of
the architecture or where sufficient strength
is assured.
• If a ceiling board such as plaster board is
too weak to support the total weight, the
area shall be sufficiently reinforced.
Avoid installing this product in the fol-
lowing locations.
• Location where it may get wet from rain or
water splash.
• Locations where a chemical agent is used
such as a swimming pool.
• Locations subject to steam and oil smoke
such as a kitchen.
• Locations near flammable gas or vapor.
• Locations where radiation or x-ray emis
-
sions are produced.
• Locations where corrosive gas is produced,
Locations where it may be damaged by
briny air such as seashores.
• Locations where the temperature is not
within –10 °C to +50 °C {14 °F to 122 °F} .
• Locations subject to vibrations (This prod -
uct is not designed for on-vehicle use.)
• Locations subject to condensation as the
result of severe changes in temperature.
Avoid moist or dusty places to install this
system.
Otherwise, lifetime of the internal parts may be
shortened.
Avoid installing this product in a place with
a high level of noise.
Installation near an air conditioner, an air
cleaner, a vending machine, or the like causes
noise.
Avoid installing and connecting during a
lightning storm. Otherwise, an electric
shock or fire may be caused.
Be sure to remove this product if it is not in
use.
Do not damage the power plug or cable.
Keep the camera cable away from the
lighting cable.
Failure to observe this may cause noise.
Radio interference
When the camera is used near TV/radio
antenna, strong electric field or magnetic field
(near a motor or a transformer), images may
be distorted and noise sound may be pro-
duced. In such a case, run the camera cable
through specialized steel conduit tubes.
PGQX1142YA_WV-CP300_G.indd 10 2012/3/30 16:53:33