![background image](http://html.mh-extra.com/html/panasonic/wv-cf624/wv-cf624_installation-manual_277773013.webp)
13
Installation
place
Applicable mount
bracket
Recommended
screw
Number
of screw
Minimum pull-out
strength (per 1 pc.)
Ceiling / wall
One-gang junction box
(locally procured)
M4
2 pcs.
196 N {44.06 lbf}
Ceiling / wall
(Direct mounting)
M4
2 pcs.
196 N {44.06 lbf}
Ceiling
WV-Q174
(approx. 310
g
{0.66 lbs})
-
-
*1
*1 Make sure that the installed mount bracket can support more than 5 times of the weight of the
camera.
When installing the camera on a wall or ceiling, two are two methods as specified below.
• Use the one-gang junction box
• Installing the camera directly on a wall or ceiling
• Using the optional ceiling mount bracket WV-Q174 (for embedded installation on a ceiling)
Important:
• Procure 2 screws (M4) to secure the camera to a wall or ceiling according to the material of the
installation area. Do not use wood screws and nails. For mounting a camera on a concrete wall
or ceiling, use an anchor bolt (M4) for securing.
(Recommended tightening torque M4: 1.6 N·m{1.18 lbf·ft})
• Required pull-out strength of a single screw/bolt is 196 N {44.06 lbf} or more.
• If a ceiling board such as plaster board is too weak to support the total weight, the installation
area shall be sufficiently reinforced.
• The protection sheet attached to the dome section should be peeled off after installation.
The mounting conditions of the camera are described as follows:
Remove the dome cover
1
Peel off the protection sheet from the dome
cover. Don't remove completely as this pro-
tects the dome during installation.
2
Loosen the dome cover fixing screw.
3
Adjust the mark on this unit to [|] on the
dome cover, and turn the dome cover
counterclockwise to remove it.
Preparations
Mark
Mark
[
|
]
NOTE:
• The clear dome cover and the inner dome
are joined into a single unit.
Therefore, never try to remove them.