English
22
Registration again
When connection with registered TV fails, or when using with another TV, re-register the 3D Eyewear.
1
Turn the TV on
2
Within 50 cm from the TV, hold the power switch on the “MODE” position for more than 2 seconds
Release the power switch when registration starts.
3
The green LED lights for 3 seconds when the registration is successfully completed
Note
If the registration failed, the 3D Eyewear will be turned off. In this case, turn off the TV and perform from step 1.
Replacing the battery
When the battery is running low, the indicator lamp flashes 5 times on turning the 3D Eyewear on.
In this case, early battery replacement is recommended.
Dispose of the old batteries as non-burnable rubbish, or in line with the waste disposal regulations in your local area.
1
Loosen the screw and remove the cover using with a precision Phillips (No.0, plus +) screwdriver
The screw is not removed from the cover.
2
Replace the battery
If difficulty, remove it with the tip of the driver.
Use the specified type of battery (coin-shaped lithium
battery CR2025).
Note the correct polarity (+ or -).
3
Replace and fasten the cover
Push the cover firmly until it clicks.
Tighten the screw.
