Panasonic VIERA TH-42PX70A, Руководство по эксплуатации

Страница: 20 / 20

FAQs, etc.
•
Licence
•
Speci
fi
cations
•
Frequently Asked
Questions
TH-42PX70A TH-50PX70A
Power Source AC 220-240 V, 50 / 60 Hz
Power Consumption
Average use 350 W 528 W
Standby condition 0.7 W 0.5 W
Display panel
Aspect Ratio 16:9
Visible screen size
106 cm (diagonal) 127 cm (diagonal)
922 mm (W) × 518 mm (H) 1,106 mm (W) × 622 mm (H)
Number of pixels
786,432 (1,024 (W) × 768 (H))
[3,072 × 768 dots]
1,049,088 (1,366 (W) × 768 (H))
[4,098 × 768 dots]
Sound
Speaker 120 mm × 60 mm × 2 pcs, 8
Ω
Audio Output 20 W (10 W + 10 W ), 10% THD
Headphones M3 (3.5 mm) stereo mini Jack × 1
PC signals
VGA, SVGA, XGA
SXGA ······ (compressed)
Horizontal scanning frequency 31 - 69 kHz
Vertical scanning frequency 59 - 86 Hz
Receiving Systems /
Band name
PAL B/G Reception of Off air broadcasts
DVB-T 7 MHz VHF / UHF (Australia) free-to-air TV broadcast reception
PAL 60 Hz Playback of NTSC tape from some PAL Video recorders (VCR)
M.NTSC Playback from M. NTSC Video recorders (VCR)
NTSC Playback from NTSC Video recorders (VCR)
Aerial - Rear Standard Belling & Lee connector
Operating Conditions
Temperature : 0 °C - 35 °C
Humidity : 20 % - 80 % RH (non-condensing)
Connection T
erminals
AV1
Input
AUDIO L - R RCA PIN Type × 2 0.5 V[rms]
VIDEO RCA PIN Type × 1 1.0 V[p-p] (75
Ω
)
S VIDEO Mini DIN 4-pin Y:1.0 V[p-p] (75
Ω
) C:0.286 V[p-p] (75
Ω
)
AV2
Input
AUDIO L - R RCA PIN Type × 2 0.5 V[rms]
VIDEO RCA PIN Type × 1 1.0 V[p-p] (75
Ω
)
COMPONENT
Y 1.0 V[p-p] (including synchronization)
P
B
/C
B
, P
R
/C
R
±0.35 V[p-p]
AV3
Input
AUDIO L - R RCA PIN Type × 2 0.5 V[rms]
VIDEO RCA PIN Type × 1 1.0 V[p-p] (75
Ω
)
COMPONENT
Y 1.0 V[p-p] (including synchronization)
P
B
/C
B
, P
R
/C
R
±0.35 V[p-p]
AV4
Input
AUDIO L - R
RCA PIN Type × 2 0.5 V[rms]
VIDEO RCA PIN Type × 1 1.0 V[p-p] (75
Ω
)
S VIDEO Mini DIN 4-pin Y:1.0 V[p-p] (75
Ω
) C:0.286 V[p-p] (75
Ω
)
Monitor
Output
AUDIO L - R
RCA PIN Type × 2 0.5 V[rms] (high impedance)
VIDEO
RCA PIN Type × 1 1.0 V[p-p] (75
Ω
)
Others
HDMI1 / 2 Input TYPE A Connectors
•
This TV supports “HDAVI Control 2” function.
PC Input
HIGH-DENSITY D-SUB 15PIN R, G, B/0.7 V[p-p] (75
Ω
)
HD, VD/TTL Level 2.0 - 5.0 V[p-p] (high impedance)
Audio Input RCA PIN Type × 2 0.5 V[rms]
DIGITAL AUDIO OUT
PCM / Dolby Digital, Fiber optic
Dimensions ( W × H × D )
1,020 mm × 750 mm × 320 mm (With Pedestal)
1,020 mm × 705 mm × 94 mm (TV only)
1,210 mm × 864 mm × 370 mm (With Pedestal)
1,210 mm × 818 mm × 94 mm (TV only)
Mass
30.0 k Net (With Pedestal)
28.0 k Net (TV only)
40.0 k Net (With Pedestal)
38.0 k Net (TV only)
38 39
Problem Actions
After DVB Auto Tuning only
some or no DVB channels are
found
•
Check to ensure your area is covered by DVB transmissions.
(www.dba.org.au/) •
Check that the aerial and antenna cable are designed for DVB.
For your safety, the aerial and cable should be inspected / installed by a
licenced installer that should comply with Australian Standard AS1417.1.
Note: If you live within 5-10 Km of DVB transmission towers, a
combined VHF / UHF aerial should be adequate. Outside this area,
separate VHF and UHF aerials provide superior reception performance.
•
If you live in a unit or apartment, check to ensure the Master
Antenna TV (MATV) system is designed for analogue and DVB-T
reception. Please consult your body corporate. (www.dba.org.au/)
Aerial connection when using
DTV and VCR / DVD Recorder
•
To maintain optimum signal quality from TV aerial, use a TV aerial splitter
(as illustrated) when connecting two or more equipments to the same aerial.
TV
VCR
(Individual aerial)
(Individual aerial)
Aerial
Input
terminal
Splitter
Aerial Output
Aerial Input
Aerial Output
DVB
•
Digital TV reception technology requires high quality, robust DTV signals which in some domestic aerial
installations, may be relatively poor despite good analogue reception.
Other
FAQs
Picture very infrequently
breaks up on some or all
channels
•
Electrical atmospheric interference caused by local or distant
lighting storms or heavy rain with wind in “leafy” locations may
cause pictures to break up and audio to mute or distort momentarily.
•
Impulse noise interference from an infrequently used electrical appliance,
or a passing vehicle or lawn mower with a “noisy” ignition system.
The remote control does not work
•
Are the batteries installed correctly? (p. 6)
•
Has the TV been switched On?
TV goes into “Standby mode”
•
Off Timer function is activated.
•
The TV enters “Standby mode” about 30 min. after broadcasting ends.
The channel cannot be selected
•
Is the channel locked? (p. 25)
The channel cannot be changed
•
Is the TV in Teletext mode? (p. 16)
TV takes so long to turn on
•
Like your computer, the TV has to run a number of diagnostic and
software checks before it can display any broadcast channels.
Picture regularly breaks up on
some channels, or
“No Signal” message
•
Check “Signal Display”. (p. 25)
If “Signal Quality” or “Signal Strength” are displayed in red or
constantly changing, check aerial.
If problem persists consult your local TV aerial installer.
•
Check that the aerial and antenna cable are designed for DVB.
For your safety, the aerial and cable should be inspected / installed by a
licenced installer that should comply with Australian Standard AS1417.1. •
Interference (known as impulse noise) from household appliances
such as light switches, fridges etc may cause picture break up and /
or audio distortion. Use high quality quad shielded coaxial cable fl y
lead between TV and antenna wall socket to minimise impulse noise
pickup. If problem persists consult your local TV aerial installer.
•
When “No Signal” message is displayed check TV aerial connection.
•
The received signal may be too weak to allow the TV to reliably lock to the
desired “No Signal” channel to generate a stable picture. Repeat the tuning
procedure (p. 24). If problem persists consult your local TV aerial installer.
Licence
Trademark Credits •
DVB is a trademark of the DVB Digital Video Broadcasting Project (1991 to 1996). •
VGA is a trademark of International Business Machines Corporation.
•
Macintosh is a registered trademark of Apple Computer, USA. •
S-VGA is a registered trademark of the Video Electronics Standard Association.
Even if no special notation has been made of company or product trademarks, these trademarks have been fully respected.
•
HDMI, the HDMI Logo and High-De fi nition Multimedia Interface are trademarks or registered trademarks of HDMI
Licensing LLC. •
HDAVI Control TM is a trademark of Matsushita Electric Industrial Co., Ltd. •
Manufactured under license from Dolby Laboratories.
Dolby and the double-D symbol are trademarks of Dolby Laboratories.
Speci fi cations
Note
•
Design and Speci fi cations are subject to change without notice. Weight and Dimensions shown are approximate.