Panasonic U-26PE1U6, Руководство по эксплуатации

Страница: 15 / 24

15
HOW TO SET ADDRESS ( )
Setting addresses of indoor units for remote controller
Setting Remote Control Addresses
1. If you press and at the same time, “SET” will blink.
2. While holding down, every time you press , it cycles from ALL 1 2 3… 6 ALL.
Set it to the receiver address switch of the indoor unit you wish to operate.
3. When you release , the address that was displayed is set.
When you do this, if it corresponds to the receiver’s address setting, the buzzer sounds.
Setting Addresses
(Setting the address of the indoor unit)
1. First of all, set the address for the remote controller with Setting Remote Control Address.
2. Press [Emergency Operation] button of the indoor unit for four seconds or more.
When you do this, the lamps of the display will blink one after another.
3. Press on the remote controller.
4. The buzzer will sound and the address of the indoor unit will change to the address displayed on the remote controller.
5. If you press [Emergency Operation] button of the indoor unit once, the lamps on the indoor unit’s display will turn off.
• Please do not hold the [Emergency Operation] button of the indoor unit down while the indoor unit’s display lamps are blinking one
after another.
• Make sure to operate while the indoor unit is stopped.
• The address of indoor unit is set to "ALL" at the time of the shipment.
Addre ss
Di s pl a y on the
Remote
Controller
NOTE
85464609338010_02_EN.fm Page 15 Wednesday, September 2, 2015 12:10 PM