15
14
To prevent damage to the
wall, make sure that the
m a i n u n i t i s s e c u r e l y
mounted on the notches of
wall mounting bracket B
(wall side) before letting go
of the main unit.
Always work in pairs or
more when installing the
unit on the wall.
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Example of
clamped cables
9a
Bundling connector cables
1
Press down on the upper section of
the clamper with your thumb and pull
the edge using your index finger to
remove the hook.
Edge
Hook
9b
Bundling cables below the connector
Outer hole
Tip
Inner hole
1
Clamp a single cable using the cable
clamper and insert the tip into the in-
ner hole.
2
Bundle all cables and insert the tip
into the outer hole.
Installation (mounting to wall)
10
Mount wall mounting bracket B (wall side)
1
Be sure to attach the fall prevention strings (2 units) on the hooks of wall mounting
bracket B (wall side).
2
Mount the main unit on wall mounting bracket B (wall side).
Cable
clamper
Clamper
2
Bundle the cables and apply the
clamper hook.
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
11
Angle adjustment
This wide-screen LCD television wall mounting bracket can be installed in 4 angles:
5° upsweep, vertical, 5° downsweep and 10° downsweep.
Set the angle by adjusting the notches of wall mounting bracket B (wall side) and the
concave section of wall mounting bracket A (main unit side) to the desired angle by
referring to the diagrams below.
5° upsweep
5° downsweep
Vertical
10° downsweep
Lower notch
Upper notch
Fixing
hole
Lower notch
Upper notch
Fixing
hole
Lower notch
Upper notch
Fixing
hole
Lower notch
Upper notch
Fixing
hole
12
Angle fixing method
To prevent the main unit from falling, fix the main unit using angle fixing screws (2
units) from both sides using the fixing holes located on wall mounting brackets A and
B (main unit side and wall side).
If the fixing holes of the brackets do not align, installation is insufficient.
Check the installation again and fix so that screw holes are aligned.
Example: When adjusting the angle to 10° downsweep.
Angle fixing screw
(M4x10 mm)
Fixing hole
Caution
