Panasonic TY-SB01F, Руководство по эксплуатации, Страница: 11 / 20

Installing the SFP module
ENGLISH ‑ 11
Installing the SFP module
This section explains an example of a procedure to install and remove the
SFP module. Please also check the operating instructions and setup guide
of the SFP module to be installed.
How to install the SFP module
SFP ports
SFP modules
Circuit boards
Fig.1
1) Remove the port cover.
f
Pull out the port cover of the SFP port.
2) Install the SFP module to the SFP port. (Fig. 1)
f
With the circuit board of the SFP module visible from the bottom,
securely insert the SFP module all the way.
f
Remove the protection cap on the <SDI OPT 1 IN> terminal, <SDI
OPT 2 IN> terminal, or <SDI OPT OUT> terminal, if there is any,
before using.
Attention
f
The removed port cover and the protection cap will be needed in following cases. Store them
so that they can be attached in the future.
g
When the SFP module not required anymore is removed
g
When there is a terminal not to be used
g
When storing the SFP module