How to Check the Operation of 3D Eyewear:
To switch the eyewear on press the power button as shown in
Fig.2
Fig.2
Power Button
TECHAD00110062010REV1
2
Power LED
3D Eyewear Battery Checks
The eyewear operates from a user replaceable 3 volt button battery cell CR2032L/1BP
.
At switch on
if the battery
voltage has fallen below
2.0 volts, the power led will blink 5 times indicating that it should be replaced.
N.B. When the battery voltage becomes low, the usable range will be affected or miss-operation may occur.
How to Confirm the 3D Eyewear Operation
To confirm the correct 3D eyewear shutter operation, switch on the eyewear as shown above
(
Fig.2
) Press the
Viera tools button on the remote control and then select the 3D icon. The 3D settings menu will be displayed, ensure
the picture display is selected from 2D to 3D. To confirm the I.R synchronising signal is being transmitted from the
television, use a mobile phone or digital video camera without an I.R filter as shown in the diagrams below.
N.B
. The LED’s will not be visible if using a camera that incorporates an I.R filter.
3D
2D
→
3D
2D
3D Auto
3D
2D: IR Output OFF
3D: IR Output ON
Your 3D Eyewear lens system is now ready to test; you will notice a change in the liquid crystal lens system, the
eyewear will change state from light to dark as shown in (
Fig.3
) The liquid crystal eyewear shutters system opens
and closes dependent on the timing signal which is controlled by the IR transmitter on your TV.
2D: IR Output OFF
3D: IR Output ON
There are 6 IR
Output LED
1. Change the switch to 2D, 3D and 2D.
FIG.3
Eyewear
2. Lenses will change from light to dark by detecting a Shutter
On/off signal From TV
if they are working
correctly
.
2D: Shutter Off
3D: Shutter On
Mobile Phone’s
camera
How to Test the 3D Eyewear Operation
The 3D glasses have a liquid crystal shutter lens system; the timing is
controlled by receiving IR signals from the TV shown in
fig 3
Eyewear
as shown above.
