Panasonic TX-PR50VT20, Руководство по обслуживанию

Страница: 32 / 170

3. For leaving the cabinet assy from the plasma panel, pull
the bottom of the cabinet assy forward, lift, and remove.
9.25. Remove the Contact metals
1. Remove the Cabinet assy. (See section 9.24.)
2. Remove the screws (x4 О ) -
3. Remove the Contact metal top.
4. Remove the screws (x6 ^ ) .
5. Remove the Contact metal bottom.
6. Remove the screws (x4 H>)-
7. Remove the Contact metal side (L, R).
9.26. Remove the K-Board
1. Remove the Contact metal bottom. (See section 9.25.)
2. Remove the screw (x1 ^ ) .
3. Remove the claw (x1 cz|>)-
4. Disconnect the connector (K1) and Remove the K-Board
from LED Panel.
9.27. Remove the V-Board
1. Remove the Contact metal bottom. (See section 9.25.)
2. Remove the screw (x1 ^ each).
3. Disconnect the connector (V1 each) and Remove the V-
Board from the Emitter fixing metal.
9.28. Replace the plasma panel
C aution:
A new plasma panel its e lf w ith o u t Hanger metals is
fragile.
To avoid the damage to new plasma panel, carry a new
plasma panel taking hold o f the Hanger metals after
assem bling the Hanger metals and the One leg bracket.
1. Place a carton box packed a new plasma panel on the flat
surface of the work bench.
2. Open a box and without taking a new plasma panel;
Attach the C1, C2, C3, C4, C5 and the C6-Board, connect
the flexible cables from the plasma panel to the C1, C2,
C3, C4, C5 and the C6-Board, and fit the flexible cable
holders.
3. Attach the Hanger metals and the One leg bracket to the
new plasma panel.
4. Place the plasma panel on the servicing stand taking hold
of the Hanger metals.
5. Attach the cabinet assy and each P.C.Board and so on, to
the new plasma panel.
*When fittin g the cabinet assy, be careful not to allow any
debris, d u s t o r handling residue to remain between the
fro n t glass and plasma panel.
32