Panasonic TX-PR46G10, Руководство по обслуживанию

Страница: 24 / 143

7.21. Remove the Front glass
1. Remove
2. Remove
3. Remove
Remove
Remove
Remove
Remove
Remove
Remove
the Cabinet assy. (See section 7.19.
the S-Board. (See section 7.20.)
the screws (x6 ^ ) .
the screws (x4 Н » .
the Glass holder side (L, R).
the screws (x8 O ) -
the Glass holder top front.
the Glass holder bottom front.
the Front glass.
7.22. Remove the K-Board
1. Remove the Front glass. (See section 7.21.)
2. Remove the screw (x2 ^ ) .
3. Remove the claw (x1 cz|>)-
4. Disconnect the connector (K1) and remove the K-Board
from LED Panel.
7.23. Remove the GL-Board
1. Remove the Front glass. (See section 7.21.)
2. Remove the claws (x3 ^ ) .
3. Disconnect the connector (GL02) and remove the GL-
Board.
7.24. Replace the plasma panel
Caution:
A new plasma panel itself without Hanger metals is
fragile.
To avoid the dam age to new plasma panel, carry a new
plasm a panel taking hold o f the Hanger metals after
assembling the Hanger metals and the Stand brackets.
1. Place a carton box packed a new plasma panel on the flat
surface of the w ork bench.
2. Open a box and without taking a new plasma panel;
Attach the C1-Board, C2-Board and the C3-Board, con­
nect the flexible cables from the plasma panel to the C1-
Board, C2-Board and the C3-Board, and fit the flexible
cable holders.
3. Attach the H anger metals and the Stand brackets to the
new plasma panel.
4. Place the plasma panel on the servicing stand taking hold
of the Hanger metals.
5. Attach the cabinet assy and each P.C.Board and so on, to
the new plasma panel.
*W hen fitting the cabinet assy, be careful not to allow any
debris, dust or handling residue to remain between the
front glass and plasma panel.
24