6
Notes:
• Main plug types vary between countries. The main plug shown at left may therefore
not be the type fitted to your set.
• The On/Off switch on this model does not full disconnect the TV from the mains
supply.
3
Replace the cover.
Do not use rechargeable (Ni-Cd) batteries.
They are different in shape and performance and may fail to ensure correct operation.
Connecting the Plug to the Wall Outlet
Battery Installation
2
B a t t e r i e s : U s e t w o “ R 6 ( A A ) ” s i z e
batteries.
Insert the batteries ensuring the correct
polarities.
This is identifiable by the “+” and “
−
” symbols
on the batteries and inside the battery
compartment.
Open the cover.
Apply slight downward pressure
while pulling towards the bottom.
1
Before Operating This Set
Two “R6 (AA)” size
How to Turn the Power On
Notes:
• When in the Stand-by condition (Refer to page 11), it is also possible to turn the TV set on by pressing any of the “Direct
Programme Number Selection buttons” (0 - 9) or “Programme Number Up or Down buttons” on the TV set or on the Remote
Control.
• If the Wall Outlet is switched OFF or the Main Plug is unplugged, when the TV set is again turned ON (by either connecting the
Main Plug to the Wall Outlet or switching the Wall Outlet ON), it will have returned to the original state.
Power OFF
Power ON
Push the Power switch on Television to turn the set on.
Power Indicator
No light: Power OFF condition
Power Indicator
No light: Normal viewing condition
Red : Stand by
Note: Even when the Power Switch is "OFF", the TV set
will still consume a small amount of power.
Power Switch
Power Indicator
The incorrect use of batteries can cause electrolyte leakage which will corrode the Remote Control or cause the
batteries to burst.
Battery cautions
Old Batteries
New Batteries
Replace both batteries at the same time.
Don't mix different battery types.
(alkaline with carbon zinc, etc.)
Don't Recharge.
