22
Common Interface Module
(DVB mode)
Press the
MENU
button.
Move to choose
Setup menu
.
Access
Setup menu
.
Move to choose
DVB Setup Menu
.
Access
DVB Setup Menu
.
Move to choose
System Setup
.
Access
System Setup
.
Move to choose
Common Interface Module
.
Access
Common Interface Module
.
Access the module.
The Common Interface Module menu provides access to software contained on Common Interface (CI) Modules.
These can be inserted in the “CI” slot located at the rear of the TV.
IMPORTANT NOTES:
• Switch off the TV using the front panel switch before inserting or removing a module.
• If you are installing a TV software update, please follow the dedicated instructions supplied with the
module.
• Insert / remove a module straightly to the CI slot.
Insert the CI module:
Some Common Interface Modules may be a two piece design consisting
of a card reader together with the viewing card. When using this design
of card,
fi
rst insert the card reader
fi
rmly into the CI slot on the TV.
Secondly, insert the viewing card into the reader.
If no module is inserted the message “No module inserted” will be
displayed.
(If you have inserted a module, check that it is fully inserted.)
The features that now appear on screen are dependent on the contents
of the selected Common Interface Module.
Refer to the instructions supplied with the card or contact the vendor.
In all cases, it is possible to navigate the pages using buttons on the
remote control, but because the commands available must apply to all
manufacturers of DVB equipment, some on screen commands may not
correspond exactly to the remote control buttons.
For example:
For the on screen command ‘
select
’ or ‘
go
’, use the
OK
button.
If you see the
symbols, use the cursor buttons.
If you see a line of key words displayed in red, green, yellow and blue,
use the coloured buttons to operate the functions.
The
EXIT
button should always allow you to exit the CI software.
Switch on the TV.
In
DVB mode
Commom Interface
Auto
3 seconds
Common Interface Module
Time Zone
DVB System Setup
Access
Display Timeout
Preferred Language Setting
Slot 1: No module inserted
Common Interface
Access
MENU
1
2
3
4
5
6
7
8
9
0
IDTV
N
OK
C
MODE
EXIT
OK