STR
TV/AV
SET UP
36
Your new TV is supplied with programme position ‘0’ set to receive an RF signal from your VCR, although a Scart connection is
preferable if the VCR is so equipped.
However, if for some reason your VCR is tuned to a different RF channel then you will not receive any picture or sound from your VCR
on programme position ‘0’ of the TV. It will be necessary to either adjust the RF channel of your VCR (some VCR’s allow adjustment of
their RF channel via their remote control unit) or to adjust the tuning of the TV’s programme position ‘0’ or both until it receives the RF
output channel of your VCR.
It is intended that this advice is used in conjunction with the instruction books for your additional equipment.
Use the AV1 Scart terminal for a VCR.
Use the AV2S Scart terminal for an S
--
Video VCR.
Use the AV2S Scart terminal for a Q
--
Link,
NEXTVIEWLINK
or compatible VCR.
To tune your TV to the VCR
Switch on the VCR, insert and play a
pre
--
recorded tape with known content
Open the Setup menu
Move to Tuning menu
Access Tuning menu
Move to Manual tuning
Access Manual tuning
Select programme position ‘0’ VCR
Start searching for the VCR playback
of the known content tape
When the VCR playback is found,
press STR to store
Press the TV/AV button to exit
See below for installation of VCR and Satellite
Receiver
Notes :
D
If picture patterning occurs on programme position ‘0’ it
may be necessary to adjust the RF output channel of
the VCR, refer to the VCR instruction book.
D
If a Satellite Receiver and a VCR are going to be used
with RF cable connections
it is important
to avoid both
units being set on the same channel.
Refer to the Satellite Receiver and VCR instruction
books for precise tuning information.
VCR AND SATELLITE RECEIVER INSTALLATION
Setup menu
Teletext
FASTEXT
Off timer
Off
Tuning menu
Access
TV/AV
Select
Access
Exit
Manual tuning
21
68
VCR
CH32
Return
--
Programme
down/up
Search
down/up
Exit
TV/AV
VCR
’STR’ Button
Store
