35
PC Card / ExpressCard
You can insert the following cards.
ExpressCard/34 or ExpressCard/54 to the ExpressCard slot (A)
PC Card Type
I
(3.3
mm
) or
II
(5.0
mm
) to the PC Card slot (B)
NOTE
The following types of card are not supported:
PC Card Type
III
(10.5
mm
), ZV card, SRAM card, FLASH ROM card (excluding ATA interface type), and other cards
that require 12 V of operating voltage.
Do not start up Windows with a storage type of CardBus PC card attached. An error may occur.
Dummy cards are inserted into both of the slots at the factory.
First remove the dummy cards (below).
Be sure to insert each dummy card when the slots are not in use.
Insert the appropriate dummy card in the correct card slot. Insert the dummy PC Card in the PC Card slot, and the
dummy ExpressCard in the ExpressCard slot.
Inserting a dummy card in the wrong slot may cause malfunction of the computer.
Preparation
Attach the device for the media containing the card driver (e.g., CD-ROM). Equipment connected to the multimedia
pocket cannot be recognized if connected after the card driver installation screen appears.
If the dummy card is inserted, remove it.
To insert the card
1
Open the cover (C), and insert the ExpressCard (D) or the PC
Card (E) with the label side up until it securely fits in to the slot.
For further information, refer to the instruction manual of the card.
To remove the card
1
Disable the card function.
A
Double-click
on the notification area and select the card, then click [Stop].
B
Follow the on-screen instructions.
This step is not necessary when removing the card after turning off the com-
puter.
Inserting/Removing the Card
