When the Power or Water Supply Is Cut Off
Automatic Electrode Cleaning
When the power supply is cut off
In case of power outage during using, the water outflow will stop. (Water run through cannot be provided.)
After power on, the Alkaline Ionizer can be used as usual. (The “purified waterˮ mode will be automatically
recovered after power on.)
When the water supply is cut off
Not available.
If water supply stops when the Alkaline Ionizer is in operation, or the water outflow is reduced due to water supply
failure, the solenoid valve (built in the main unit) will automatically closed after about 1 minute.
After the water supply is recovered, please open the faucets except for the special faucet for Alkaline Ionizer, so
the tap water (raw water) flow can discharge the air or dregs in pipes. The Alkaline Ionizer can be subsequently
used as usual. (The service life of the cartridge may be greatly shortened if air or dregs enter the main unit.)
It will be cleaned automatically after each using.
Automatic cleaning after using for a while
Once the alkaline ion water or
weak acidic water has been
used for 10 times
After every 160 hours
About 2 minutes after
the water stops by pressing
Water
Stop/Flow
After water run through of alkaline ion water or purified water
After pressing
Water
Stop/Flow
After using weak acidic water
When the total run through water
volume of alkaline ion water or
weak acidic water reaches 10 L
After every 12 hours
when unused
Conduct automatic cleaning of the electrode
(the longest time is about 35 seconds)
Conduct the automatic electrode cleaning
(about 18 seconds ~ 35 seconds)
(The alarming sound of “PI PI PI PI ...” will be continuously made for about 3 seconds).
About 5 seconds after the weak
acidic water inside the main unit
is discharged from the main
spout, the water outflow will stop.
During and after the cleaning process, water may dip from the main
spout and drain outlet in a short time, which is a normal phenomenon.
After the automatic cleaning process, the flashing time of the water
signal indicator will be longer (about 15 seconds) in the subsequent
water run through (to discharge the water used for cleaning).
The water signal indicator will
flash in red.
When discharging the water,
all the buttons on the control
panel cannot be used.
Notes
Notes
Please do not drink the water
flows out from the main spout or
drain outlet at this time.
The water signal indicator will be on.
( The red light will be on for about
10 seconds, and blue light will
be on for about 8 seconds ~
25 seconds)
Important
Note
The inside of the main unit will be cleaned automatically under the following conditions.
EN22
01_TK-AB50-ZEX_ZMA_EN.indd 21
2018/09/10 11:11:58
