48
Using Network Function
This unit has a network function to control the network connected display with your computer.
Note:
To use the network function, set each “Network Setup” setting and make sure to set the “Control I/F Select” to “LAN”.
(see page 44)
When “LAN” is set, power indicator lights orange under the condition of power “Off” with remote control (stand-by
state).
Example of Network Connection
Command Control
Notes:
• Make sure the broadband router or hub supports 10BASE-T/100BASE-TX.
• To connect a device using 100BASE-TX, use “category 5” LAN cable.
• Touching the LAN terminal with a statically charged hand (body) may cause damage due to its discharge.
Do not touch the LAN terminal or a metal part of the LAN cable.
• For instructions on how to connect, consult your network administrator.
Network function of the unit can control the unit in the same way as serial control from a network.
Supported commands
Commands used in the serial control are supported. (see page 15)
Note:
Consult your local Panasonic dealer for detail instructions on command usage.
Display (main unit, rear)
Hub or broadband router
LAN cable
(not supplied)
COMPUTER
