Panasonic TH-50PF20U, Руководство по эксплуатации

Страница: 11 / 25

Conversion adapter
(if necessary)
Mini D-sub 15p
RGB
PC cable
Stereo mini plug (M3)
Audio
Connect a cable which matches
the audio output terminal on the computer.
(Male)
(Female)
COMPUTER
11
PC Input Terminals connection
Notes:
• With regard to the typical PC input signals that are described in the applicable input signals list, adjustment values such
as for the standard picture positions and sizes have already been stored in this unit. You can add up to eight PC input
signal types that are not included in the list.
• Computer signals which can be input are those with a horizontal scanning frequency of 15 to 110 kHz and vertical scanning
frequency of 48 to 120 Hz. (However, the image will not be displayed properly if the signals exceed 1,200 lines.)
• The display resolution is a maximum of 1,440 × 1,080 dots when the aspect mode is set to “4:3”, and 1,920 × 1,080
dots when the aspect mode is set to “FULL”. If the display resolution exceeds these maximums, it may not be possible
to show
fi
ne detail with suf
fi
cient clarity.
• The PC input terminals are DDC2B-compatible. If the computer being connected is not DDC2B-compatible, you will need
to make setting changes to the computer at the time of connection.
• Some PC models cannot be connected to the set.
• There is no need to use an adapter for computers with DOS/V compatible Mini D-sub 15P terminal.
• The computer shown in the illustration is for example purposes only.
• Additional equipment and cables shown are not supplied with this set.
• Do not set the horizontal and vertical scanning frequencies for PC signals which are above or below the speci
fi
ed
frequency range.
• Component Input is possible with the pin 1, 2, 3 of the Mini D-sub 15P Connector.
• Change the “COMPONENT/RGB-IN SELECT” setting in the “SET UP” menu to “COMPONENT”
(when COMPONENT signal connection) or “RGB” (when RGB signal connection).
Signal Names for Mini D-sub 15P Connector
Pin Layout for PC Input
Terminal
Pin No. Signal Name Pin No. Signal Name Pin No. Signal Name
1
R (P
R
/C
R
)
6
GND (Ground)
11
NC (not connected)
2
G (Y)
7
GND (Ground)
12
SDA
3 B (P
B
/C
B
) 8 GND (Ground)
13
HD/SYNC
4
NC (not connected) 9 +5 V DC
14
VD
5
GND (Ground)
10
GND (Ground)
15
SCL
Connections
1
6 7 8
3
9
4 5
10
15 14 13 12 11
2