8
9
Quick Start Guide
Connection
Accessories/Options
D I G I T A L
A U D I O
O U T
S E R V I C E
O N L Y
A N T
IN
OUT
ANT IN
ANT OUT
S Video
OUT
Video
OUT
Audio
OUT
L
R
Video
IN
Audio
IN
L
R
Y
PB
PR
Y
PB
PR
COMPONENT VIDEO
INPUT
INPUT 1
INPUT 2
OUTPUT
S VIDEO
1
2
L
R
VIDEO
AUDIO IN
D I G I T A L
A U D I O
O U T
S E R V I C E
O N L Y
A N T
2
Setting-up
3
Preventing the plasma television from falling over
* Carry out work on a horizontal and level surface.
Lift the television unit above the pedestal base,
with the back of the television unit on the same
side as the Pedestal No. label. Then align the
holes in the television unit with the poles of the
pedestal and lower the television unit into place.
Use the assembly screws
B
(M5 x 30) to fasten
securely.
Accessories/Options
Securing to a base.
Securing to a wall.
* Remove the screws
at both top corners on
the rear side of the
plasma TV, and attach
the clamps
to the
plasma TV using the
removed screws.
* Use strong wire
or chain which is
commercially available
to secure the plasma
television to a solid
area of the wall or a
pillar.
Connection
■
Watching TV
Back of the unit
Cable BOX
S-Video signals have
priority.
or
VHF/UHF aerial
DVD Recorder /
VCR
Fastener
•
To unfasten
AC cord
(Connect after
all the other
connections.)
Note
•
All cables and external equipment shown in this
book are not supplied with the TV.
•
For additional assistance, visit us at www.
panasonic.com
•
The S Video input will override the composite
video signal when S Video cable is connected.
Connect either S Video cable or Video cable.
•
When receiving digital channel signals, all digital
formats are down-converted to composite NTSC
video to be output through the PROG.OUT
terminals.
•
Some programs contain a copyright protection
signal to prevent VCR recording.
•
Set the TV channel to CH3 or CH4 for using
Cable Box Connection.
Video recorder
with TV Tuner
To record TV shows
or
Remove the plasma television unit from its packing box, spread a clean blanket or other covering on a level
floor or stand, place the television on the floor or stand with its front panel facing down, and keep it like this
until installing it on the pedestal.
Securing the television unit
* The plasma TV must be fastened to both the base and the wall.
Pedestal No. label
Pedestal
Television unit
Rear
Front
Front
Wood
Worktop
Fasten with wood screws in the holes
in the back edge of the wood worktop.
If there are no holes, first drill them in
the middle of the thickness of the wood
worktop, and then fasten the strap with
wood screws.
• Securing method
Screws on main body
Do not remove this screw.
Attaching the Cable clampers
•
Do not bundle the RF cable and AC cord together (could
cause distorted image).
•
Fix cables with Cable clampers as necessary.
•
When using the optional accessory, follow the option’s
assembly manual to fix cables.
Snap open
Back of the TV unit
Snap shut
