Setting Up the TV
|
Connecting the TV
6
Removing the pedestal from the TV
Be sure to remove the pedestal in the following way
when using the wall-hanging bracket or repacking the
TV.
1
Lay the TV on a foam mat or thick soft cloth on a
table.
2
Remove the assembly screws
from the TV.
3
Pull out the pedestal from the TV.
4
Remove the assembly screws
from the bracket.
Wall mounting the TV (optional)
Choosing to wall mount the TV shall be done at the
owner’s risk. Always use a qualified installer to perform
a TV wall bracket installation. Incorrect fitting may cause
equipment to fall, resulting in injury and product damage.
Any such damage will void your warranty.
b
a
Rear of the TV
Screw for fixing the TV onto the
wall-hanging bracket (not supplied)
Depth of
screw
(View from the side)
■
Holes for wall-hanging bracket installation
a:
200 mm
b:
200 mm
■
Screw specification
Type of screw:
M4
Depth of screw:
Minimum: 9 mm
Maximum: 14 mm
Warning
●
When optional accessories such as wall brackets etc.
are used, always read and follow the manufacturer
installation and usage instructions.
●
Do not mount the unit directly below ceiling lights (such
as spotlights or halogen lights) which typically give
off high heat. Doing so may warp or damage plastic
cabinet parts.
●
When installing wall brackets you must ensure the wall
bracket is not electrically grounded to metal wall studs.
Always ensure that there are no electrical cables,
pipes etc. in the wall before you begin the wall bracket
installation.
●
To prevent fall and injury, remove the TV from its fixed
wall position when it is no longer in use.
Connecting the TV
●
Please ensure the TV is disconnected from the mains
socket / power point before attaching or disconnecting
any RF / AV leads.
●
External equipment and cables are for illustrative
purposes only and not supplied with this TV.
●
Check the type of terminals and cable plugs are
correct when connecting.
●
When using an HDMI cable, use the fully wired one.
●
Keep the TV away from electronic equipment (video
equipment, etc.) or equipment with an infrared sensor.
Otherwise, distortion of image / sound may occur or
operation of other equipment may be interfered.
●
Also read the manual of the equipment being
connected.
Terminals
5
4
6
Rear of the TV
2
3
1
1
HDMI 1 - 2
2
AV IN
3
AUDIO OUT
4
Aerial terminal
5
DIGITAL AUDIO OUT
6
USB port
This symbol indicates DC operation.
TH-32F400AZ_EN-1.indd 6
TH-32F400AZ_EN-1.indd 6
2/1/2018 1:20:32 PM
2/1/2018 1:20:32 PM
