7
WARNING:
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK OR PROD-
UCT DAMAGE, DO NOT EXPOSE THIS APPLIANCE TO RAIN,
SPLASHING, DRIPPING OR MOISTURE.
CAUTION!
THIS PRODUCT UTILIZES A LASER.
USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF
PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY
RESULT IN HAZARDOUS RADIATION EXPOSURE.
DO NOT OPEN COVERS AND DO NOT REPAIR YOURSELF.
REFER SERVICING TO QUALIFIED PERSONNEL.
The product you have purchased is powered by a nickel-cadmium bat-
tery which is recyclable. Please call 1-800-8-BATTERY for information
on how to recycle this battery.
CAUTION:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful inter-
ference in a residential installation. This equipment generates, uses and can ra-
diate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or televi-
sion reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the
following measures:
≥
Reorient or relocate the receiving antenna.
≥
Increase the separation between the equipment and receiver.
≥
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
≥
Consult the dealer or an experienced radio/TV technician for help.
Any unauthorized changes or modifications to this equipment would void the
user’s authority to operate this device.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including interference
that may cause undesired operation.
Ni-Cd
RBRC
RBRC
Attaching the Beltclip
Attach the included beltclip to make it easier to carry while jogging.
1
Insert the flange on the belt-
clip into the slot on the base
of the unit.
2
Press the beltclip firmly
against the base.
3
Fit the screw into the hole in
the unit.
4
Screw in the direction indi-
cated.
5
Clip on to your belt.
Beltclip
Maintaining the Lens
Open the lid and clean the lens as
shown in the figure.
Use a cotton swab to gently wipe
off any finger-prints.
Recommended product:
Lens cleaner kit (SZZP1038C)
Air blower for
camera lens
Lens
Lens
Product Service
Do not attempt to remove the cover(s) or repair the unit yourself. Refer servicing to
qualified personnel only.
Product information
For product service, product information or assistance with product operation, refer to
the servicenter directory.
