Insert the digital transceiver into the slot of your home
theater unit.
Connecting the digital transceiver
Digital transceiver
Insert fully until you hear a click.
Rear of the home theater unit
Do not insert or remove
while the home theater
unit is on.
e.g.
Connecting the surround speaker cables
to the wireless system
1
If the surround speaker cables have already been connected
Disconnect the surround speaker cables from your
home theater unit.
2
Connect the surround speaker cables to the wireless
system.
AC IN~
L
R
Flip the tab open.
Insert the wire
fully.
i
: White
j
: Blue
Flip the tab closed.
Click!
To household mains
socket
(AC 230 to 240 V,
50 Hz)
AC mains lead
Surround speaker cable (L)
Surround speaker cable (R)
Refer also to the operating instructions for your home theater unit.
Conserving power
The wireless system consumes a small amount of power when it is in standby
mode (approx. 4 W).
To save power when the unit is not to be used for a long time, unplug it from
the household mains socket.
[Note[
The unit is in the standby condition when the AC power supply cord is
connected. The primary circuit is always “live” as long as the power cord is
connected to an electrical outlet.
Making the wireless link
1
Turn on your home theater unit.
≥
Ensure the wireless system is connected to the mains socket.
2
Check the wireless link indicator on the home theater
unit.
W
“
[W]
” or LED should light up on the home
theater unit.
≥
If
“
[W]
”
or LED is flashing, refer to
Troubleshooting guide.
e.g.
AC IN
WIRELESS LINK
AC supply indicator [AC IN]
This indicator lights when the unit is connected
to the AC mains supply.
Lighting Ring
Lights when the wireless link is active.
3
Start play on the home theater unit.
8621-B En.fm Page 3 Wednesday, April 26, 2006 8:33 AM