4
Connecting and positioning
Preparation
≥
Turn off all equipment before connection and read the appropriate operating instructions.
≥
Connect the AC power supply cord after all other connections are complete.
Insert the digital transmitter into the slot.
1
If the surround speaker cables have already been connected
Disconnect the surround speaker cables from
the subwoofer.
2
Connect the surround speaker cables to the
receiver.
∫
Wireless setup diagram
e.g.
≥
Place the digital receiver within approximately 10 m (33 feet) from the home
theater main unit.
[Note[
≥
Do not use more than two surround speakers when using this wireless
system.
≥
Do not use this wireless system near a microwave oven.
≥
Do not place the transmitter or receiver in a metal cabinet or bookshelf.
Connecting the digital transmitter
Connecting the surround speaker cables
to the digital receiver
Digital transmitter
Insert fully until you
hear a click.
Rear of your home theater system
Do not insert or
remove while your
home theater
system is on.
AC IN~
L
R
1
2
3
Flip the tab open.
Insert the cable into the
terminal.
Flip the tab closed.
Click!
To household AC outlet (AC 120 V, 60 Hz)
AC power
supply cord
Color of the cables
i
: White or Copper
j
: Blue or Silver
Surround
cable (L)
Home theater main unit
Surround speaker
cables
Digital receiver
Refer also to the operating instructions for your home theater system.
1
Power on your home theater system.
2
Power on the receiver.
3
Start play on your home theater system.
RF SECTION
Wireless module
Frequency range
2.402 to 2.480 GHz
No. of channels
79
Bandwidth/Channel
1 MHz
RF output power
14 dBm (Max)
RF output impedance
50
≠
Type of emissions
Data rate
1 Mbps
AMPLIFIER SECTION
Output power
RMS output power
Surround Ch
70 W per channel (4
≠
), 1 kHz, 10 % THD
FTC output power
Surround Ch
45 W per channel (4
≠
), 20 Hz–20 kHz, 1 % THD
GENERAL
Power supply
AC 120 V, 60 Hz
Power consumption
Digital transmitter
0.3 W
Digital receiver
35 W
Dimensions (W
t
H
t
D)
Digital transmitter
97 mm
k
47.5 mm
k
8.5 mm (3.8
zk
1.9
zk
0.3
z
)
Digital receiver
103 mm
k
215 mm
k
178 mm (4
zk
8.5
zk
7.0
z
)
Mass
Digital transmitter
0.03 k
g
(0.07 Ibs)
Digital receiver
2.1 k
g
(4.6 Ibs)
Operating temperature range
r
5
o
C to
r
35
o
C (
r
41
o
F to
r
95
o
F)
Operating humidity range
5 % to 90 % RH (no condensation)
[Note]
1. Specifications are subject to change without notice.
Mass and dimensions are approximate.
2. Total harmonic distortion is measured by a digital spectrum analyzer.
Power on/off
W
“
[W]
” lights up in the display on
your home theater system.
(“
[W]
” is flashing
➜
page 1,
Troubleshooting guide)
Power indicator
This indicator lights when the unit is turned on.
Wireless link indicator
This indicator lights when the signal strength is
adequate for proper operation.
Power on/off button
Press!
Specifications
7992En&Cf.fm Page 4 Wednesday, April 6, 2005 6:17 PM
