RQTX0208
6
6
ENGLISH
FM outdoor antenna
(not included)
75
Ω
coaxial cable
(not included)
Rear panel of
this main unit
Optional antenna
Optional antenna connections
connections
AM outdoor antenna
(not included)
Rear panel of
this main unit
AM loop antenna
(included)
Use outdoor antenna if radio reception is poor.
Note:
• Disconnect the outdoor antenna when the unit is not in use.
• Do not use the outdoor antenna during a lightning storm.
FM outdoor antenna
AM outdoor antenna
• Disconnect the FM indoor antenna.
• The antenna should be installed by a competent technician.
• Run a piece of vinyl wire horizontally across a window or
other convenient location.
• Leave the loop antenna connected.
Preparing the remote control
Use alkaline or manganese batteries.
Insert so the poles (+ and –) match those in the
remote control.
2
3
1
LR6/R6, AA
Aim at the remote control signal sensor (
\
page 7), avoiding obstacles, at a
maximum range of 7 m directly in front of the unit.
Note on using the remote control
• Do not mix old and new batteries.
• Do not use different types of batteries at the same time.
• Do not take apart or short circuit the batteries.
• Do not attempt to recharge alkaline or manganese batteries.
• Do not use batteries if the covering has been peeled off.
• Do not heat or expose to fl ame.
• Do not leave the battery(ies) in an automobile exposed to direct sunlight for a
long period of time with doors and windows closed.
• Mishandling of batteries in the remote control can cause electrolyte leakage,
which may cause a fi re.
• Remove the batteries if the remote control is not going to be used for a long
period of time. Store in a cool, dark place.
CAUTION
Danger of explosion if battery is incorrectly replaced. Replace only with the
same or equivalent type recommended by the manufacturer. Dispose of used
batteries according to the manufacturer’s instructions.
DEMO function
When the unit is fi rst plugged in, a demonstration of its functions may be shown
on the display.
If the demo setting is off, you can show a demonstration by selecting “DEMO
ON”.
Press and hold [
7
, –DEMO] (demo) on the main unit.
The display changes each time you press and hold the button.
$%-//&&
$%-//.
While in standby mode, select “DEMO OFF” to reduce power consumption.
Making the connections (continued)
PMX4_EP_EN.indd 6
PMX4_EP_EN.indd 6
12/23/08 2:37:36 PM
12/23/08 2:37:36 PM
